HQ Power VDPLCW Notice D'emploi page 4

• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
a) Tripods
• Set up the two tripods and slide the T-connectors on top. Secure with the screw.
• Connect the three crossbars and slide the connected bars through the opening on top of the curtain until the end
of the crossbar appears at the other end.
• Slide the exposed ends of the crossbar into the T-connections.
• Adjust the height of the tripods as desired.
• Connect the controller to the 5-pin connector.
b) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation must be approved by an expert prior taking it into service.
c) Controller
1. sensitivity adjustment of the pre-programmed effects
2. pre-programmed effects selection knob
3. built-in microphone for sound-controlled mode
4. controller input connection
5. DMX output
6. DMX input
7. DIP switches for address configuration
8. power switch
9. fuse
d) Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Remove the fuse holder at the back of the device.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder.
VDPLCW
4 HQPOWER