Technical Data - Renkforce A-1000 Mode D'emploi

There is distortion:
• The amplifier input receives an excessive signal.
• The volume is set too high, the speakers distort.
• The sound controllers for bass and treble are turned up too far.
• The control source is a high-level device and has been connected to the phono input of the amplifier
incorrectly.
Playback has no bass share:
• One speaker is connected the wrong way.
• The BASS controller (15) on the amplifier is set to minimum.
Playback has no treble share:
• The TREBLE controller (14) on the amplifier is set to minimum.
Repairs other than those described above must only be carried out by an authorised specialist.

15. Technical Data

Supply voltage: .................................................. 230 V/50 Hz
Power consumption:.......................................... 100 W
Loudspeaker impedance: ................................. 6-8 Ohm
Input sensitivity/impedance: ............................ Line
Output power: ..................................................... 2 x 50 W at 6 Ohm
Total harmonic distortion: ................................. <0,05 %
Frequency response: ......................................... 20-20000 Hz (+1/-2 dB)
S/N ratio:.............................................................. Line
Channel separation:........................................... 60 dB
Sound controller:................................................ Bass
Dimensions:......................................................... 420 x 135 x 215 mm
Weight: ................................................................. 6.2 kg
250 mV/47 kOhm
Phono 2.5 mV/47 kOhm
70 dB(A)
Phono 60 dB(A)
+/-10 dB/100 Hz
Treble +/-10 dB/10 kHz
41