Playing An Audio Source; Recording - Renkforce A-1000 Mode D'emploi

b) Playing an Audio Source
• Turn the volume control VOLUME (5) all the way to the left.
• Turn the controllers TREBLE (14) and BASS (15) to the middle position.
• Switch on the audio sources, such as your CD player, cassette deck, etc.
• Turn on the amplifier with the POWER button (1).
• Select the desired input source (e.g. CD player) with the input selection buttons (9-13).
• Turn the sound control (5) clockwise until you reach the desired volume.
• Use the controllers TREBLE (14) and BASS (15) or the button PRESET EQ (4) to change the sound.
• To switch off the amplifier, turn the volume controller VOLUME (5) all the way to the left again and then
switch off the amplifier with the button POWER (1).
If you do not observe this sequence, the speaker of the amplifier could be damaged.
c) Recording
• Select the desired recording source (e.g. CD player) with the input selection buttons (9-13).
• Push the recording button at the recorder. The recorder must be connected to the sockets TAPE REC.
• The volume setting and sound settings do not affect the recording.
36