Operating Phases - Pfeifer HIT 125 Traduction Du Manuel D'utilisation Original

G) Turn on the lifter by rotating the lever mechanism to
the MAG position and lock the lever on the lever stop
(see operating cycle description).
H) Move the load observing applicable standards for
handling any suspended loads. – No one should be in
the operating area
I) Set the load on the floor or support before releasing
it, being careful that the load is perfectly settled on the
floor or support and that the support is adequate for the
load.
L) To release the load, manually move the lever stop pin
and rotate the lever system to the DEMAG position
(see operating cycle description). This operation must
be carried out by energetically grasping the lever
system with one hand (right or left), by moving the
machine stop pin with the other hand and by simultane-
ously rotating the lever system all the way to the rotary
limit switch ("DEMAG" position).
The above mentioned operations must be performed
in compliance with ap-plicable work standards and
other standards for suspended load handling.
NOTE
– No one should be in the operating area.

5.3 Operating phases

Magnetization phase
Magnetization
1) Firmly move the lever from DEMAG to MAG
(Fig. 1).
2) Make sure the lever is perfectly locked by the lever
stop mechanism (Fig. 2).
Magnetization
DEMAG
Lever stop mechanism
Demagnetization phase
Demagnetization
1) Grasp lever Armly and move the pin of the lever stop
system in direction of arrow (Fig. 1).
2) Firmly but gently move lever to DEMAG while rotating
(Fig. 2).
Demagnetization
MAG
HIT Manual lifters 08/2015 / Subject to technical changes!
Magnetized lifter
MAG
Demagnetized lifter
DEMAG
9