Led Flashing Sequences And Transmission Behaviour; Mounting In Existing Switches - REV MAX! Mode D'emploi

• Wait 60 seconds.
• Press and hold down the button at the top or bottom.
• Re-insert the batteries at the same time.
• Press and hold down the button until the device LED
starts to flash.
• Release the button. The factory settings are restored.
The LED's flashing sequences have different meanings:
Flashing sequence Meaning
1x flash
2x flashes
3x flashes

10. Mounting in existing switches

The MAX! Eco Switch is designed to fit into frames
supplied by the following manufacturers:
Manufacturer
Berker
ELSO
GIRA
merten
JUNG
9. LED flashing sequences and
transmission behaviour
Confirmation following successful sending
of the radio command
Duty cycle has been exceeded. The longest
period to wait before sending again would
be an hour.
Error message, radio command not sent
successfully
Frame
S.1, B.1, B.3, B.7 glass
Joy
System 55, Standard 55, E2,
E22, Event, Espirit
1-M, Atelier-M, M-Smart,
M-Arc, M-Star, M-Plan
A 500, AS 500, A plus, A creation
19