Mounting - REV MAX! Mode D'emploi

• Put the pushbutton back into the frame.
Never recharge standard batteries. Doing so
will present a risk of explosion. Do not throw the
batteries into a fire. Do not short-circuit batteries.
Used batteries should not be disposed of with
regular domestic waste! Instead, take them to
your local battery disposal point.
You can either use screws or adhesive strips to mount the
MAX! Eco Switch to a wall in the frame supplied or integrate
it into an existing switch (see Section 10 for more detailed
information about compatible switches).
Adhesive strip mounting:
T h e s u r f a c e o n w h i c h y o u a r e m o u n t i n g t h e
pushbutton must be clean and dry.
• At tach the adhesive str ips to the rear of the
m ounting plate.
• Remove the protective film from the adhesive strips.
• Press the rear of the mounting plate to the wall where
the MAX! Eco Switch will subsequently be attached.
The arrow on the mounting plate should point upwards.
16

6. Mounting

<PA66>