REV MAX! Mode D'emploi page 17

• Attach the frame to the mounting plate.
• Attach the electronic unit to the frame, on the mounting
plate. Make sure that the clips on the mounting plate
latch into the openings on
the electronic unit.
Screw mounting:
• Position the mounting plate on the wall. Make sure that
the arrow on the mounting plate is pointing upwards.
• Use a pen to mark the positions of the bore holes (a) in
the mounting plate on the wall.
• Use the screws and plugs supplied to fasten the plate
to the wall.
• Next, attach the frame to the mounting plate.
• Attach the pushbutton. Make sure that the clips on
the mounting plate latch into the openings on the
electronic unit.
Holes do not have to be drilled and plugs do not have to be
used for mounting on a flush-mounting box.
You c an even use a f r am e supp li e d by anot her
manufacturer or integrate the electronic unit into a multi-gang
frame. Read the information about compatibility in Section 10.
a a
17