End Of Work - Bourgini 11.3128.00.00 Mode D'emploi

EN
If you do not need to adjust the temperature,
please press the ENTER key to directly start the
work.
3. After the temperature is adjusted, press the
ENTER key (18) to start the work.
4. The time-delay " " function is not available for
the descaling program. After it is completed, the
system directly enters the END interface.

END OF WORK

1. After a program is ended, "END" appears on
the display screen, and the buzzer will beep
10 times, this indicates that the cooking is
completed. Afterwards, you can open the door
(8) to take out the food or the system will
automatically switch to standby mode after five
minutes.
2. After the program is over, paused or in standby
mode the display screen will show the high-
temperature "
temperature is over 50 °C. The internal fan will
also continue working for 3 minutes.
3. After the steam function program is completed
the " " icon will flash on the screen as a
reminder to take out the water tank (5), drain
the water in the evaporator and then pour away
the residual water from the cooking tray. The
icon will flash for 1 minute.
Note: removal of residual water icon is displayed
only when steam-related functions are used while
evaporating heater is working.
DO IT YOURSELF (DIY) FUNCTION MODES
No Icon Explanation
1 Steam
2 Strengthening heating (Back heater
convection + top heater pipe + bot-
tom heater pipe)
3 Top Heater pipe
" icon as long as the oven
4 Top/bottom heater pipe
5 Hot air convection (Top Heater pipe
+ rear fan)
6 Back heater convection (Back hea-
ting + rear fan)
7 High-temperature steaming (steam +
Back heater convection)
DIY steam
Adjustable temperature range: 50-110 °C,with an
adjusting scale of 5 °C.
In the standby status, open the oven door (7),
take out the water tank (5) to fill the water to its
maximum scale; put in the water tank and food and
then close the oven door (7).
Press the selection key " > " (17) to enter the
steam mode. At this time, the steam icon
flash, and the indicator light of water tank/time/
temperature is ON. Press the ENTER
key, hour icon will shine. Press the SELECTION key
(15 & 17) to select the time as required (default
value is 0, ranging from 0-6). After it is selected,
press the ENTER key (18) to enter the minute
selection mode and then, the minute icon will flash.
Press the SELECTION key (15 & 17) to select the
required time (default value is 30, ranging from
0-59). After it is selected, press the ENTER key
(18) to enter the temperature selection mode and
then, the temperature icon will flash. Press the
SELECTION key (15 & 17) to select the required
temperature (default value is 100, ranging from 50-
110). After the selection, press the ENTER key (18).
will
24