Bourgini 11.3128.00.00 Mode D'emploi page 23

DIY-mode
When the menu is selected, the "steam" function
icon in upper left corner is ON. Press the selection
key " > " (17) to enter the function selection mode.
The display column on the left side of the screen
will show the corresponding function icon, as shown
in the following figure. There are 9 DIY regular
function modes. Each gear of the key corresponds to
a function. The key moves a gear, the function icon
will automatically jump down to flash, and the frame
will not flash. After the desired function is selected,
it can be confirmed by press the ENTER key
Descaling
When the menu "Descaling" is selected, the icon
is ON to remove the scale. (Working time of 50
minutes is not adjustable. The work process cannot
be paused)
Setting of working hours and temperature in
DIY mode:
After the desired function is selected, it can be
confirmed by pressing the ENTER key (18) to
enter the setting of working hours. The hour bit
will flash. Press the selection key (15 & 17) to
set the hour bit. After it is confirmed by pressing
the ENTER key (18), the minute bit will flash, and
then press the selection key (15 & 17) to set the
minute bit. After it is confirmed by pressing the
ENTER key (18), the temperature bit will flash, and
then press the selection key (15 & 17) to set the
working temperature. After the setting of working
temperature is finished, press the ENTER key (18) to
start working.
For example, the setting of "Top heater pipe"
working mode:
1. Select function
2. Setting of working hours
23
3. Setting of working hours and temperature, top
heater pipe icon "
START WORK
Attention: all functions shall be adjusted to this
(18)
adjustment order except for the fixed time and
temperature.
Note: water tank icon will be displayed when a
steam-related function is selected (such as, steam,
high-temperature steam, ferment, unfreeze etc.),
For example:
DURING THE WORK
Pause
During all functions, the machine will pause if the
ENTER key (18) is pressed, the working time
will stop the countdown, the display interface will
stay in the working state interface, and the time bit
number will keep its original data of flash and beat,
which indicates that the machine is in a working
status of pause. Press the ENTER key (18) again and
the machine continues working until the process is
completed.
Add time and adjust temperature midway during
cooking / steaming / baking / roasting / air frying
process.
(Only adjustable in DIY function)
1. Press Setting key (13) "
delay" icon " " on the screen is ON. At this
time, the minute bit will flash. The minute bit can
be adjusted by pressing the selection key "<"
">" (15 & 17) (setting of hour bit is not available
for delay time function).
2. After the minute bit is adjusted, press the ENTER
key (18) to enter the setting of temperature.
" will flash.
" until the "Time-
EN