Indel B TB Série Instructions D'utilisation page 16

ENGLISH
INSTALLATION
- Place the refrigerator on a dry, sheltered, flat surface and away from any edges. The refrigerator must
not be used unsheltered, in the open air or exposed to splashing or rain.
- Your refrigerator requires good ventilation, especially around the back of the refrigerator, allow a gap of
at least 15 cm around the sides, back and top. Never use your refrigerator in the boot of a car or against.
- Do not install the refrigerator near heat sources, sunlight.
- Should you need to leave the device under the sun for long periods, eg. in a car or in other vehicles,
make sure you protect it, to prevent the cover plastic materials from getting damaged or warped.
- To fix it inside the car and to avoid damages during transport, we suggest to secure the fridge trough
metal brackets placed on the sides
- Avoid introducing liquids or ice not inserted in containers
- Do not put hot food items into the refrigerator.
- Avoid using the refrigerator under the rain or in presence of water.
USING THE REFRIGERATOR IN A VEHICLE
TB45A-TB55A
- Connect the feeding cable to a direct current 12 or 24 V DC power source.
- Make sure the polarity is right.
- The supply line is protected by a 15 A fuse located on the box.
- If connected to an existing cigarette plug, carefully check up that power supply is sufficient.
- If the supplied power cable is not used, see the table containing the information related to the cable
section:
CABLE AREA
2,5 (AWG 13)
14
2
mm (AWG)
4 (AWG 11)
6 (AWG 9)
TB31A-TB41A-TB51A
MAX CABLE LENGHT METRES (ft)
12V
2,5 (8 FT)
4 (13 FT)
6 (20 FT)
TB SERIES
24V
5 (16FT)
8 (26 FT)
12 (40 FT)
TB_SERIES_27-04-2018