Manual Operation - Brandt CFP-1015 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

In the event of fault or malfunction
where the appliance is not to be used,
turn off the appliance and do not
attempt to repair. If a repair is required,
contact a Technical Assistance Service
authorised by the manufacturer and
request the use of original spare parts.
If the cable for this appliance is
damaged, contact an authorised
Technical Assistance Service for it to be
replaced.
Do not leave the appliance exposed to
the elements (rain, sun, ice, etc.).
Do not use or let any part of the
appliance come into contact or near
hot surfaces (kitchen gas or electric
hobs or ovens).
Do not use detergents or abrasive
sponges to clean the appliance.
Do not touch the hot surfaces. Use the
handles.
Do not let the cable come into contact
with the hot parts of the appliance.
Do not allow all the liquid to evaporate.
Do not heat an empty jug.
Do not use a broken jug or one with a
loose or weakened handle. In the event
of any sign of deterioration, replace it,
as any crack or chip could break the jar
or contaminate the liquid contents with
shards of glass.
Do not clean the jug with any abrasive
scourer or cleaner which could scratch
or weaken the glass.
The jug is designed to be used with this
appliance. Do not place the jug on or
near any hot surface (stoves, burners,
hotplates, hot ovens, microwave ovens,
etc.).
Do not place the jug on a damp or cold
surface.
Avoid brusque handling of the jug and
knocks.
4. BEFORE USING THE APPLIANCE
FOR THE FIRST TIME
Before using your coffee maker for the
first time, familiarise yourself with all the
parts. Read all the instructions carefully.
Open the container lid (2) upwards
(Fig 2), take out the filter and the filter
holder (Fig. 3) and clean them, the jug
and the jug lid in warm soapy water.
Rinse well, dry them and reassemble
them.
To clean the inside, operate the coffee
maker twice in succession without
any ground coffee in the filter. For this
process, follow the instructions under
the heading "Preparing your coffee".
5. PREPARING YOUR COFFEE
Place the coffee maker on a flat, stable
surface.
Open the container lid (2) upwards (Fig
2) and fill it with clean, cold water up
to the desired level. Do not exceed the
container's maximum level.
Fill the permanent filter (8) with the
amount of ground coffee you desire
and close the lid. We suggest one flat
dessertspoonful of ground coffee per
cup of coffee. After using the coffee
maker a few times, you may adjust the
amount of coffee to taste.
Place the jug (4), with its lid (3) duly
assembled, on the hotplate (5). Make
sure the jug lid opens the anti-drip
valve, otherwise the filtered coffee will
not flow through into the jug and will
overflow out of the filter.
Take the cord out of the cord
compartment (18) and plug it in to the
mains.

6. MANUAL OPERATION

Connect the coffee maker by pressing
the on switch
come on.
The switch light will indicate that the
appliance is in operation. The water will
start to filter through the coffee maker
into the jug.
When the coffee maker is in operation,
only the switch works
Disconnect the coffee maker by
pressing the on/off switch
do not disconnect the coffee maker,
10
(11). The red light will
.
(11). If you

Publicité

Table des Matières
loading

Table des Matières