Initial Use - Beurer BC 51 Mode D'emploi

6. Initial use

Inserting the batteries
• Remove the battery compartment lid on the right side of the
device.
• Insert two 1.5 V AAA micro (alkaline type LR03) batteries. Make
sure that the batteries are inserted the correct way round in ac-
cordance with the markings. Do not use rechargeable batteries.
• Close the battery compartment lid again carefully.
• All display elements are briefly displayed,
described below.
If the battery replacement symbol
must replace all batteries. Once the batteries have been removed from the device, the date and time
must be set again. Any saved measured values are retained.
Making settings
You must make sure that the device has the correct settings before use in order to be able to make
full use of all functions. Only by doing so can your measurements with associated date and time be
saved and accessed later by you.
There are two different ways to access the menu from which you can adjust the settings:
• Before initial use and after each time you replace the battery:
When inserting batteries into the device, you will be taken to the relevant menu automatically.
• If the batteries have already been inserted:
With the device switched off press and hold the START/STOP button
onds.
In this menu you can adjust the following settings in succession:
Hour format
➔
flashes, you can no longer perform any measurements and
Date Time
➔
flashes on the display. Now make the settings as
36
for approx. 5 sec-