Setting The Massage Position - Massage; Switching Off - tomado TFW0302G Mode D'emploi

Switching on
The control unit has two switches. One for regulating the heating position and one for regulating the massage position.
Set the switch to the required position. The functions can be set and used separately.
Setting the heating position - heat
HIGH: maximum heating - high
OFF: off
LOW: minimum heating - low

Setting the massage position - massage

HIGH: maximum massage - strong vibration
OFF: off
LOW: minimum massage - low vibration
ATTENTION
The foot warmer heats up the fastest when you first switch on a higher temperature position.
ATTENTION
The foot warmer has been provided with an inner pad, in which the heating and massage elements are located.
If you feel little to nothing at the maximum position (massage or heating), it is possible that the inner pad has been
placed in the foot warmer the wrong way around. First always remove the plug from the socket. Remove the inner
pad and carefully take the inner pad out of the foot warmer. Take the cord into account and turn the inner pad around
in such a way that the other side is on top, but the cord is still at the rear. Place back the inner pad and insert the plug
in the socket.
WARNING
• The maximum duration of use is 15 minutes per session. Longer use results in a shorter life span
of the appliance and could lead to tension in the muscles instead of relaxation.
• Long use of the foot warmer could lead to overheating. Allow the foot warmer to cool down before using it again.

Switching off

Set both switches to OFF in order to switch off the foot warmer.
ATTENTION
If the foot warmer is not being used, you must switch it off and remove the plug from the socket. Then disconnect
the adapter from the switch.
EN - 18