Before The First Use; Cleaning And Maintenance; Technical Data - tomado TM-7502 Mode D'emploi

BEFORE THE FIRST USE

• Turn the heater on its side and screw on the included
legs with the supplied screws.
• Place the device on a flat stable surface and ensure
a minimum of 10 cm. free space around the device.
This device is not suitable for installation in a cabinet
or for outside use.
• Put the power cable into the socket. (Note: Make sure
the voltage which is indicated on the device matches
the local voltage before connecting the device.
Voltage 220V-240V 50/60Hz)
• When the device is turned on for the first time, a slight
odor will occur. This is normal, ensure adequate
ventilation. This fragrance is only temporary and will
disappear soon.
USE
• Put the plug into a grounded outlet and switch on the
device with the controls.
• For low-power heating, switch only the lower switch,
the red light comes on.
• Turn the thermostat clockwise to its highest position. If the
room temperature is reached, turn the thermostat switch
counter clockwise until you hear a click. The thermostat
will keep the room temperature the same. For high power
heating, turn the upper switch, the red light comes on.
• Never place objects on the heater, such as clothing
or towels. Never use the heater in the bathroom or
other wet areas. The air outlets of the heater can be
very hot.

CLEANING AND MAINTENANCE

• Before cleaning, unplug the appliance and wait for
the appliance to cool down.
• Clean the appliance with a damp cloth. Never use
harsh and abrasive cleaners, scouring pad or steel
wool, which damages the device.
• Clean the two air outlets (above and below) by using
a vacuum cleaner to remove dust from inside.

TECHNICAL DATA:

Type no.: TM-7502
Power: 1300-1500 W
Mains voltage: 220-240V~ 50 Hz
Dimensions: 17,8 x 49,5 x 35,3 cm
Net weight: 2,1 KG
Instruction manual TM-7502
9