Velleman CAMSETW3 Mode D'emploi page 4

You're getting a weak signal or there is interference :
• Reorient the antenna of the monitor.
• Set the same channel for the camera and monitor (same channel for both, of course).
• Make sure there is no microwave between or in close proximity to the camera and the monitor. If so, deactivate it
or move it.
• Do not exceed the max. distance of ± 100m between the camera and the monitor.
Maintenance
• Only reorient the antennas if the picture quality is unsatisfactory.
• Keep this device away from children and unauthorised users.
• Fingerprints or smudges on the lens can affect picture quality. Do not touch the lens with your fingers.
• Only use the monitor indoors and do not place it in dusty, moist, hot or very cold environments.
• Do not try to open the housing to avoid damage to the device.
• Only use the included power supply or one with identical technical specifications.
• Do not overload the used outlets and extension cords to avoid all risks of electroshocks and fire.
• The signals of your system may also be received by other devices using the same 2.4GHz frequency. Even
conversations in rooms close to the camera may be broadcast. Deactivate the camera when you don't need it in
order to guarantee your privacy.
Specifications
Frequency
A/V mod/demod. Method
Channels
Antenna
Dimensions (B x H x D)
Weight
Power supply
Operating temperature
The specifications can be subject to change without prior notice.
CAMSETW3
CAMERA
built-in omnidirectional antenna
10.5 x 13 x 11.5cm
300g
9Vdc, 500mA
-10 ~ 40°C (14 ~ 104°F)
¼" CMOS image sensor
Effective pixels
EIA: 320 (H) x 240 (V)
CCIR: 352 (H) x 288 (V)
Lens: f 3.6mm, F 2.0
- 4 -
2.4GHz
FM
4 selectable channels
directional antenna
15 x 19 x 17cm
13.5Vdc, 1000mA / 10 type C batteries
0 ~ 40°C (32 ~ 104°F)
5.5" B/W monitor
Max. sound output: 800mW
MONITOR
1400g
Resolution
V: 350 lines
H: 300 lines
NL