Publicité
CHECKING THE SPARK PLUG
– Only use the supplied universal wrench to remove or to install the spark plug.
– The gap between the two electrodes of the spark plug should be 0.7 - 0.8 mm
(0.028" - 0.032"). If the gap is too wide or too narrow, adjust it. If the spark plug is
clogged or contaminated, clean it thoroughly or replace it.
Place the plug cap properly as illustrated after checking.
CAUTION: N ever touch the spark plug connector while the engine is running (danger of high
voltage electric shock).
SUPPLY OF
GREASE TO
GEAR CASE
– Supply grease (Shell Alvania 2 or equivalent) to the gear case through the grease
hole every 30 hours. (Genuine MAKITA
on the ground or dirty place. Otherwise they it
may damage the engine.
cleaning the elements. Fuel may damage
38
Publicité
Chapitres
