Maintenance And Storage - Tractel Group EN 354 Instructions D'emploi Et D'entretien

Maintenance and storage

See figure 3 on page 2.
• If a lanyard becomes dirty, wash it in clean cold water, possibly
with a detergent for delicate fabrics, using a synthetic-fibre
brush.
• When the lanyard becomes wet, either during use or washing,
leave it to dry naturally in the shade and away from all sources
of heat.
GB
Tractel S.A.S. RN 19-Saint Hilaire sous Romilly-F-10102
Romilly-sur-Seine France hereby declares that the safety equip-
D
ment described in this manual.
• complies with the requirements of European Directive
89/686/EEC of December 1989.
• is identical to the PPE, having been subject to the "CE0082"-
type-examination certificate issued by the Apave SUDEURO-
PE, B.P.193, F-13322 Marseille cedex 16, identified under the
number 0082, and tested according to the 2002 EN 354 stan-
dard.
• is subject to the procedure referred to in Art. 11B of Directive
89/686/EEC, under the control of a notified body: TÜV
Rheinland Product Safety GmbH - Am Grauen Stein D - 51105
Köln, identified under the number 0197.
The label on each lanyard indicates:
a: The trade name: Tractel,
b: The name of the product: eg: LC 1.5 - 10 -10 (Longe Corde),
c: The reference standard followed by the year of application,
d: The product reference: eg: 010642,
e: The EC logo followed by the n° of the Article 11 B notified
body for 0197 production inspection,
f: Year and week of manufacture,
g: The serial number,
h: A pictogram showing that the manual must be read before use.
Periodical inspections and repairs
• For safety purposes, the operator shall carry out regular perio-
dical inspections of the equipment to ensure its efficiency and
resistance.
• An annual service is obligatory, though depending on the
amount of use, the environmental conditions and the company
regulations or the legislation of the country of use, periodical
inspections can be more frequent.
• Periodical inspections must be carried out by a competent per-
son and by respecting the manufacturer's recommendations for
inspection procedures.
• Check the readability of the product's marking during periodical
inspections.
Lanyards are products that cannot be repaired. Should they
show the least signs of damage, they must be destroyed.
8
Conformity
Marking