ZAZU Otto the otter Guide D'utilisation page 2

MANUAL
OCEAN PROJECTOR
Take the module out of the plush and place 3x AA batteries
(not included). Put the module back into the plush.
Open the Velcro, on the bottom, to operate the buttons.
Only use alkaline batteries, no zinc carbon.
Switch on the product by pressing the big
A
Choose your favourite melodie with
B
OFF: No music
1 Ocean sound
2 Lullabies
3 Heartbeat
Set the preferred volume: high-low,
C
Switch the cry sensor ON/OFF,
D
when the cry sensor is activated, the sleep program
will restart from phase 2, to calm down and settle
your baby.
Auto-off: the entire 3 step sleep program will automatically
switch OFF after 30 minutes.
D
SAFETY GUIDELINES
- Important! keep for future reference.
- This ZAZU product is fully compliant with the EU, CA, AU, NZ, USA
and CN legislation.
- Please keep the packaging away from small children.
- Never allow your child to play with the batteries.
- This product works with 3x AA 1.5 V batteries (not included).
- Only use the specified batteries.
- Remove empty batteries from the product.
- Batteries should only be placed by adults.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-Zn), or rechargeable
Ni MH) batteries.
BUTTON A
SLIDER B.
SLIDER C
SLIDER D
A
B C
3 STEP SLEEP PROGRAM
Otto/Cody will calm and sooth your baby
to sleep with the unique 3 step sleep program.
The total program takes 30 minutes and will
automatically switch off.
STEP 1 Calming your child
Follow the waves and the orange
fish swimming around the room,
while listening to soothing
ocean sounds.
0-10 MIN
STEP 2 Getting sleepy
Lower brightness, moving waves
and only a few fish swimming
around the room. Music changes
to underwater bubbles.
10-20 MIN
STEP 3 Falling asleep
Non moving waves and fish.
No sounds.
20-30 MIN
For the best projection, locate the product within
1 to 2.5 meters from the walls and ceiling. When
batteries lose their power, the projection decreases,
and the product might lose some of the features.
- When not in use please switch the product OFF completely.
- Do not place inside the cot or too close to the baby.
- The plush can be washed by hand and air dried, but remove
the module beforehand.
- This light does not get warm.
- This product is intended for indoor use and is not water resistant.
Please keep dry. For cleaning do not immerse in water, but wipe
with a damp cloth.
- Do not try to disassemble the product if it stops working.
Please contact customer service.
Manufactured and distributed by ZAZU
PO Box 299 | 3740 AG Baarn
The Netherlands | info@zazu-kids.nl
EN