Detachable Speakers; Speaker Connection; Sound Control - Sharp GX-CD1200W Mode D'emploi

DETACHABLE SPEAKERS

1 2
3
Right speaker
SPEAKER (8 )
RIGHT LEFT
Red
Black

SOUND CONTROL

Volume X-BASS
Graphic equalizer Surround
GRAPHIC EQUALIZER
10 10
0
10 10
500Hz 2kHz 10kHz
Set the FUNCTION switch to STAND-BY before con-
necting or disconnecting the speakers.
Mounting the speakers to the main unit
Fit the grooves of the speaker to the guides on the main unit,
and then slide the speaker all the way down to lock it in place.
Removing the speakers from the main unit
Push the RELEASE lever as shown in the illustration to unlock
the speaker, and then lift up the speaker to remove it from the
main unit.

Speaker connection

Connect each speaker wire to the SPEAKER terminals as
shown. Use speakers with an impedance of 8 ohms or more,
Left speaker
as lower impedance speakers can damage the unit.
Caution:
Connect the black wire to the minus (–) terminal, and the
red wire to the plus (+) terminal.
Do not mix the right channel and left channel wiring when
connecting the speakers to the unit.
Do not let bare speaker wires touch each other as this may
damage the amplifier and/or speakers.
Do not stand or sit on the speakers. If the speakers fall or
collapse, you may be injured.
Red
Note:
The speaker grille is not removable.
Volume
Rotate the VOLUME control towards MAX to increase the vol-
ume, and towards MIN to decrease the volume.
X-BASS
Extra bass (X-BASS)
MAX
Move the X-BASS control towards MAX to emphasise bass
sound.
The centre position represents a normal setting.
MIN
Graphic equalizer
Move the GRAPHIC EQUALIZER control for any frequency
towards + 10 to boost the level for that frequency, and towards
-10 to lower the level.
Surround
"Surround" refers to an acoustical effect similar to the ambi-
ence of a concert hall, where the listener has the feeling of
being "surrounded" by the sound.
To enjoy the surround effect:
Set the SURROUND switch to ON.
Note:
The surround effect cannot be
obtained from monaural sound
signals.
E-5