Installation Instructions; Unpack The Wine Cellar; Reverse Door Swing - Jenn-Air JUW24FRACX Guide D'utilisation Et D'entretien

Overlay Frame - Rear View
Create the custom overlay frame using the dimensions shown.
IMPORTANT: The following graphic shows a custom frame for a
door with the hinges installed on the right-hand side. If your
refrigerator has the hinges installed on the left-hand side, rotate
the custom frame 180° so the hinge markings will be on the left.
⁷⁄₁₆ ³⁄₈
¹⁄₂
1 1
"
" "
(3.55 cm) (3.8 cm) (8.2 mm)
¹⁄₄
2
"
(5.7 cm)
⁵⁄₃₂
"
¹⁄₂
"
(4.0 mm)
(1.0 cm)
³⁄₈
1
"
(3.42 cm)
⁵⁄₁₆
2
"
(5.9 cm)
3
(8.5 cm)
³⁄₈
3 "
(8.5 cm)
¹⁄₂
23 "
(59.6 cm)
³⁄₁₆
30 "
(76.6 cm)
⁷⁄₈
2 "
(7.4 cm)
¹⁵⁄₃₂
A. Drill holes using a " (12 mm) drill bit to a depth of approximately
¹⁄₂
" (13 mm) before routing. (4 holes total)
⁵⁄₁₆
B. Drill holes using a " (8 mm) drill bit to a depth of approximately
¹⁄₂
" (13 mm) before routing. (4 holes total)
⁷⁄₆₄
C. Drill holes using a " (2.8 mm) drill bit to a depth of approximately
¹⁄₂
" (13 mm). (12 holes total)
D. Rout shaded areas for hinges to a
E. Rout shaded areas for hinges to a
¹⁄₈
F. Corner radius of " (3 mm) using a
(5 radiuses total)
6
¹⁄₂
"
(1.1 cm)
A B
¹⁄₂
1
"
(3.8 cm)
D E
³⁄₈ ³⁄₈ ³⁄₈ ³⁄₈ ³⁄₈
" 3 " 3 " 3 " 3
(8.5 cm) (8.5 cm) (8.5 cm) (8.5 cm)
¹⁄₂
1
"
(3.7 cm)
18"
(45.6 cm)
³⁄₈
3 "
(8.5 cm)
³⁄₄
23 "
(60.3 cm)
¹⁹⁄₃₂
" (15 mm) depth.
¹⁄₄
" (4 mm) depth.
¹⁄₄
" drill bit when routing

Unpack the Wine Cellar

C
Use two or more people to move and install wine cellar.
Failure to do so can result in back or other injury.
Remove the Packaging
F
Remove tape and glue residue from surfaces before turning
on the wine cellar. Rub a small amount of liquid dish soap over
¹⁄₈ the adhesive with your fingers. Wipe with warm water and dry.
" 2 "
(5.2 cm)
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your wine cellar. For
more information, see "Wine Cellar Safety."
Dispose of/recycle all packaging materials.
When Moving Your Wine Cellar:
Your wine cellar is heavy. When moving the wine cellar for
cleaning or service, be sure to cover the floor with
cardboard or hardboard to avoid floor damage. Always pull
the wine cellar straight out when moving it. Do not wiggle
or "walk" the wine cellar when trying to move it, as floor
damage could occur.
Clean Before Using
After you remove all of the packaging materials, clean the inside of
your wine cellar before using it. See the cleaning instructions in
"Wine Cellar Care."

Reverse Door Swing

The door hinges are factory installed on the right-hand side. If you
want the door to open from the opposite direction, you must
reverse the door.
IMPORTANT: To avoid strain on the hinges, it is recommended
that you use two people to remove the door.
Tools Needed: Phillips screwdriver and a ¹⁄₈" hex key wrench.
Remove the Door
1. Unplug or disconnect power and remove any items that might
be stored inside.
INSTALLATION
INSTRUCTIONS
WARNING
Excessive Weight Hazard
(optional)