Door Closing
Door Closing
Your wine cellar has four leveling legs. If your wine cellar seems
unsteady or you want the door to close more easily, adjust the
wine cellar's tilt using the instructions below.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
WARNING
Excessive Weight Hazard
Use two or more people to move and install wine cellar.
Failure to do so can result in back or other injury.
2. Move the wine cellar into its final location.
3. Turn the leveling legs to the right to lower the wine cellar or
turn the leveling legs to the left to raise it. It may take several
turns of the leveling legs to adjust the tilt of the wine cellar.
NOTE: Having someone push against the top of the wine
cellar takes some weight off the leveling legs. This makes it
easier to adjust the leveling legs.
4. Open the door and check that it closes as easily as you like. If
not, tilt the wine cellar slightly more to the rear by turning both
front leveling screws to the right. It may take several more
turns, and you should turn both leveling legs the same
amount.
WINE CELLAR USE
Normal Sounds
Your new wine cellar may make sounds that your old one didn't
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the flooring and surrounding structures, can
make the sounds seem louder. The following describes the kinds
of sounds and what may be making them.
Your wine cellar is designed to run more efficiently to keep
your wine at the desired temperatures and to minimize energy
usage. The high efficiency compressor and fans may cause
your wine cellar to run longer than your old one. You may also
hear a pulsating or high-pitched sound from the compressor
or fans adjusting to optimize performance.
Rattling noises may come from the flow of refrigerant or items
stored inside the wine cellar.
As each cycle ends, you may hear a gurgling sound due to the
refrigerant flowing in your wine cellar.
You may hear water running into the drain pan when the wine
cellar is defrosting.
You may hear clicking sounds when the wine cellar starts or
stops running.
Using the Control
The control is located behind the base grille. Lift up on the door in
the center of the grille to access the control.
For your convenience, your wine cellar temperature control is
preset at the factory. When you first install your wine cellar, make
sure that the control is still preset to the mid-setting as shown.
Adjusting the Control
The mid-setting should be correct for normal usage. The control is
set correctly when the wine is as cold as you like.
If you need to adjust the temperature, wait at least 24 hours
between adjustments and then recheck the temperature.
To make the wine cellar colder, adjust the control to the next
higher setting. To make the wine cellar less cold, adjust the control
to the next lower setting.
NOTE: Adjusting the temperature control raises or lowers the
temperature in both the upper and lower zones (compartments).
9