Protector WA-11 Mode D'emploi page 17

Requirements
The TUYA app* must be installed on
your smartphone. Your smartphone
must be on the same Wi-Fi network
as the WA-11.
Add WA-11
Open the TUYA app and tap the plus
symbol to add a device.
Select the category "Security sensor"
and scroll in the overview to "High
water detector".
Tap on "Flood detector (WiFi)".
Select your WLAN and enter the cor-
responding password, then tap on
"next".
If the WiFi LED on the WA-11 does
not flash quickly, press and hold the
RESET button for a few seconds.
Confirm in the app that the LED is
flashing quickly and then tap "next".
The unit will now be added, this pro-
cess can take up to 2 minutes. If your
WA-11 is not found, follow the
instructions in the app and try again.
*If you have not yet installed the
TUYA app, depending on the smart-
phone you are using, open the Apple
App Store or the Google Play Store
and install the Tuyasmart app.
MALFUNCTIONS
Alarm cannot be switched off
using the RESET button.
If the alarm cannot be deactivated
via the RESET button, water is still
detected. This can happen, for exam-
ple, if water has entered the sensor.
In this case, unplug the water alarm
from the socket and leave the sensor
dry. You can also disassemble the
sensor and then dry it with a dry
cloth.
No alarm even though both
sensor electrodes are immersed
in water.
1. sensor electrodes have no contact
with the sensor cable > Check the
crimping of the ring cable lugs.
17
ENGLISH | WA-11