Protector WA-11 Mode D'emploi page 16

WA-11 | ENGLISH
You will need the ring cable lugs sup-
plied, a small Phillips screwdriver and
pliers (e.g. combination pliers). First
unscrew the housing screw (7) with
the screwdriver and remove the
cover from the sensor. After that, the
two electrode screws are exposed,
which you can now also unscrew.
Be careful, as this will also loosen the
electrodes.
Use the pliers to shorten the cable,
taking care not to cut off too much.
Remove the outer insulation at the
interface for a length of approx. 15
mm and the insulation of the wires
for approx. 5 mm, measured from
the interface. Slide a ring terminal
onto one of the two stripped cores
and then crimp the rear part of the
ring terminal together with the
pliers. Alternatively, the cores can
also be soldered to the cable lugs.
SETTINGS
Function selector switch (11)
Use this selector switch to set whe-
ther a connected device is to be swit-
ched ON or OFF. Slide the switch to
the AUS position (crossed-out
socket) to switch off a connected
unit if the sensor electrodes (9) come
into contact with water. When the
switch is in the EIN position, the
water alarm switches on the connec-
ted appliance.
Alarm volume switch (10)
With this switch you can set the
volume of the alarm in 3 levels. MAX
is the loudest level, MIN is the quie-
test level.
RESET button (3)
A short press on the RESET button
resets the detector after water has
been detected.
TUYA APP (WIFI)
The WA-11 can be connected to the
wireless LAN to display the status via
the TUYA app. In addition, the TUYA
app can send a push notification to
your smartphone when water is
detected.
16