Table des Matières
Publicité
14
Installation
Nailing Brackets – Standard Install
The fireplace has nailing brackets on both sides. Secure the fireplace to the framing.
NOTE: Make sure the fireplace is square and plumb when placed in the framing. Measured corner-to-
corner the fireplace should be square. Use shims to insure the fireplace is square.
NOTE: The nailing brackets have two positions: standard and extended. See the section "Facing
Requirements" for details on which position is best for your installation.
NOTE: if you can not use the front nailing
brackets, an additional bracket is supplied on
the side that allows the fireplace to be secured
to the floor (bend tab down and secure).
Standard Position
(nailing brackets as shown below)
© Travis Industries
(pour des installateurs qualifiés seulement)
a
Rotate the two nailing
brackets out (each side)
c
d
Extended Position
(rotate nailing brackets as shown below)
10/20/2021-1372-FR
b
Bend the two nailing
brackets out (each side)
Bend this 5/8" (16mm) tab
back. It acts as a standoff
and helps center the fireplace
in the framing.
Secure the fireplace to
the framing using the
nailing brackets
3615 HO GSR2
Publicité
Table des Matières
