Lc Display Indication - Conrad VOLTCRAFT Lux DL-230L Notice D'emploi

b) LC display indication
• Some settings are not indicated on the LC display. To check the settings, refer to chapter
"12 h) Checking the configuration settings".
• If there is not any display indicator or once the data logger starts/stops recording, the latest
measurement is shown on the display.
Mode Start mode
1 No display indicator
2 No display indicator
3 No display indicator
4
5
6
7
8
52
Stop mode
Not applicable
No display indicator
Not applicable
No display indicator
Not applicable
Remarks
The red LED (2) flashes when the memory is full.
To stop the recording, press and hold down the
"ENTER" button (8) for a few seconds.
The red LED (2) flashes when the memory is full.
To start the recording, press and hold down the
"ENTER" button (8) for a few seconds.
To start and stop the recording, press and hold
down the "ENTER" button (8) for a few seconds.
To start the recording, press and hold down the
"ENTER" button (8) for a few seconds.
The red LED (2) flashes when the memory is full.
To stop the recording, press and hold down the
"ENTER" button (8) for a few seconds.