Conrad VOLTCRAFT Lux DL-230L Notice D'emploi page 40

Ready to start recording by holding down the "ENTER" button (8) for a few seconds.
(When configuring, select "Logging start condition": "Start upon Keypress")
The recording can be stopped by holding down the "ENTER" button (8) for a few
seconds.
(When configuring, select "Logging end condition": "Stop button")
Ready to enable the limit pause function by holding down the "ENTER" button (8) for
a few seconds.
Ready to disable the limit pause function by holding down the "ENTER" button (8) for
a few seconds.
Days, unit for remaining time. (If the remaining time is below one day, remaining time
is shown in HH:MM format.)
Ready to upgrade firmware.
Measurement error
Measured values are beyond the measuring range.
Configuration error. An error occurred during configuration. Repeat the configuration
process.
40