Conrad VOLTCRAFT Lux DL-230L Notice D'emploi page 51

Mode 11
Feature
Setting
Mode 12
Feature
Setting
Mode 13
Feature
Setting
For modes 1 through 13, you can use additional functions for the delay of the logging start time. When
configuring, enter a value under "Start delay in minutes".
The data are logged immediately and in an infinite loop.
The logging will stop as soon as the battery is empty or the configuration is replaced by
another "Logging start condition".
• As "Logging start condition", select: "Continuous logging"
The data are logged immediately and in an infinite loop.
For an additional stop mode, select: The logging will stop if you press and hold down the
"ENTER" button (8) for a few seconds.
• As "Logging start condition", select: "Continuous logging"
• As "Logging end condition", select: "Stop button"
The data are logged immediately and in an infinite loop.
For an additional stop mode, select: Logging stops after PDF report is generated.
• As "Logging start condition", select: "Continuous logging"
• As "Logging end condition", select: "After PDF creation"
51