Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
Initialization & voltage display:
After connecting the lamp to the battery, the software runs a selftest. The lamp itself as well as the
red and blue LEDs in the switch light up once. The
LEDs, as follows:
The blue LED fl ashes once for each volt; and then
the red LED fl ashes once for each 1/10 of a volt.
Example:
The LED fl ashes seven times blue and fi ve times red = battery voltage is 7.5 V.
Interpreting the voltage display:
more than 8.0 V
battery is fully charged:
7.1 to 7.8 V
battery needs charging
6.5 to 7 V
battery is not ready for use
Turn on:
The fi rst press of the button switches on the light with maximum power. The blue LED is illuminated.
Switching:
Each quick push of the button switches through the dim levels.
Turn off :
To turn off the lamp, keep the button pressed.
Note:
The light outputs the maximum amount of light only if airfl ow lowers the temperature of the
light suffi ciently. If the light is not cooled by airfl ow, its power is reduced
LEDs and electronic elements from overheating.
20
Piko
battery voltage
is indicated by the blue and red
incrementally
to prevent the
The switch on the lamphead is equipped with a RGB-LED to show informations about
the dim level and the remaining battery capacity.
blue LED lit:
Lamp is on high beam.
green LED lit:
Lamp is on a lower beam.
red LED lit:
1. Battery Warning, low capacity remaining.
The red LED is lighting.
You can adjust the timing of the battery warning,
see progamming on next page.
red LED fl ashing +
2. Battery Warning, very low capacity remaining.
light fl ashing once:
The red LED is fl ashing and Piko fl ashing ones, too.
blue + red LED
Warning!
fl ashing in turn +
The red and blue LED fl ashing in turn, the lamp fl ashes 30
light fl ashing 5 times:
times.
blue + red LED
After switching the light on again, reserve power at a low beam
fl ashing in turn:
is available.
light will be switched off automatically. So slow down!
Note:
depends on the total battery capacity, the ambient tempera-
ture and the age of the battery.
Meaning of LED colours
Stop immediately! The light will be switched off .
When reserve power is completely discharged, the
The burn time remaining after the red LED is illuminated
Piko
21
Publicité
Table des Matières
