Maintenance Instruction - Maxspect Jump Série Mode D'emploi

Maintenance of the fixture
User must periodically perform maintenance on the fixture, including but not limited
EN
to the following steps:
Use a damp cloth to clean the acrylic lens to make sure it is not covered by salt
•
creep or other dirt and debris. Uncleaned lens will severely affect the luminous
output of the fixture, so for best performance you should clean the lens once a
week.
Clean the dust and debris trapped in the fan units. Regularly and properly cleaned
•
fans will last much longer than those that are not. Fan unit is wear-and-tear parts
and must be replaced every 24-36 months depends on the frequency of
maintenance performed on them.
Clean / remove any salt creep or dirt and debris that had been built up or collected
•
on the aluminum body of the fixture, as they may affect the dissipation of heat from
the fixture.
Note: Failure to perform the above-mentioned maintenance on the fixture may cause
unnecessary damage to your fixture and may void your warranty!
Specifications
For the latest specifications on LED layout, types and color spectrum, please visit our
website www.maxspect.com, or scan below QR-Code.
14

Maintenance Instruction