Preparation; Installing The Plasma Display - Pioneer PDP-5050HD Mode D'emploi

Preparation

Installing the Plasma Display

Over 50 cm (19
Over 10
cm (3 15 /
16
inches )
Illustration shows PDP-5045HD/4345HD.
Locating
• Avoid direct sunlight. Maintain adequate ventilation.
• The length of the system cable used to connect the Plasma
Display and the Media Receiver is about 3 m (9.8 feet).
• Because the Plasma Display is heavy, be sure to have
someone help you when moving it.
• If you place anything on the top of the Media Receiver it will
not receive enough ventilation and will not operate properly.
• Allow enough space around the upper and back parts when
installing to ensure ventilation around the backside.
11 / inches)
16
Using the optional PIONEER stand
For details on installation, refer to the instruction manual
supplied with the stand.
• This product may be used only with model PDK-TS04 stand.
Use with other stands may result in instability causing
possible injury.
Using the optional PIONEER speakers
For details on installation, refer to the instruction manual
supplied with the speaker.
Operating Environment
Operating environment temperature and humidity: +0°C to
+40°C (+32°F to +104°F); less than 85% RH (cooling vents not
blocked)
Avoid installing at the following locations:
• Under direct exposure to sunlight
• Under strong artificial light
• In high humidity
• Poorly ventilated
06
15
En