Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Shutdown (Fig. A)
1. To stop the pressure washer, rotate the ON/OFF switch
to the OFF position and unplug the cord from the outlet.
2. Turn OFF water at the faucet.
3. Discharge residual pressure by squeezing the trigger
until no more water comes out of the spray wand
4. Engage the spray handle lock-off
5. Disconnect the garden hose from the water intake
6. Disconnect the high pressure hose
pressure water outlet
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Nozzle
If the nozzle becomes clogged with foreign materials, such as
dirt, excessive pressure may develop. If the nozzle becomes
partially clogged or restricted, the pump pressure will pulsate.
Clean the nozzle immediately using the nozzle cleaner.
1. Shut OFF the pressure washer unit
water supply.
2. Pull trigger
6
on spray handle
water pressure.
3. Remove the nozzle from the spray wand
the quick connect collar
4. Using the spray tip cleaning tool
from the nozzle.
5. Run water from a faucet or garden hose through the nozzle.
Soap Tank (O, P)
To clean the soap tank, decouple the hose from the pump.
1. Shut OFF the pressure washer and turn OFF the
water supply.
2. Pull trigger on gun handle to relieve any water pressure.
3. Decouple the soap tank hose
hose inlet
47
.
4. Lift the soap tank
11
5. To clean the soap tank
detergent back into its bottle. Use water from a garden
hose to thoroughly rinse out the tank. Empty the tank
and allow it to dry.
8
5
.
1
from the high
43
and drain the hose.
7
and turn OFF the
3
to relieve any
2
by pulling
45
toward the spray wand.
14
, unclog any debris
46
from the soap tank
out of the pressure washer unit
11
, empty any remaining
Fig. O
8
6
.
2
46
10
.
47
Fig. P
11
7
Storage (Fig. Q)
•
Store in a dry, covered location above freezing
temperature. sTORE inDOORs.
•
Always completetely empty water from high pressure
hose, pressure washer unit, spray wand, nozzles, soap
bottle, and pressure wand handle.
•
Nozzles can be stored on the cross member as shown
in Fig. Q.
Fig. Q
7
.
Publicité
Table des Matières
