Description; General; Preface; Safety Instructions - Hexagon m&h IRP40.02 Manuel D'instructions

Description

1 Description
1.1

General

1.1.1

Preface

It is imperative that the safety information contained in these operating instructions is strictly observed to guarantee
the safe and reliable operation of the touch probe and avoid personal injury and damage to property. The meaning of
the symbols related to the safety instructions is described in the table below:
NOTICE
INFORMATION
1.1.2

Safety Instructions

Risk of material damage!
•
Manual or automatic positioning of the probe must be protected, in a way that the machine axis stops feeding
if the probe is triggered during its move to the position where actual measuring should begin!
Risk of material damage!
•
Feedhold or spindle-stop resulting from a trigger or ready signal from a touch probe should only happen if the
probe is actually in the spindle. This security logic will protect the machine against a possible spindle or
feeding stop under normal milling operation if a signal from a probe reaches the control under one of the
conditions outlined below:
•
Battery replacement and subsequent functional check of the touch probe by manually switching it on.
Risk of property damage!
•
Only the original spare parts listed in these operating instructions are permitted for preventive and
correctional maintenance.
The information given in this manual can be changed by the manufacturer at any time. The user is therefore
responsible for regularly enquiring about updated information.
26
NOTICE indicates important information that, if not observed, could lead to
property damage / malfunctions.
INFORMATION indicates important information or helpful advice for working with
the described device.
NOTICE
NOTICE
NOTICE
INFORMATION
IRP40.02