Eneo VMC-17LCD-HP Mode D'emploi page 13

3. Operating Instruction
FRONT controls
4. SELECT ( ) / Mode Change
This button to choose on the menu then
pushes the button: While in the normal active
(NOT MENU DISPLAY) mode, press this button to
change input VGA, CVBS, S-VIDEO (while in the VGA
mode change over two seconds press
While in the VGA mode, press this button to AUTO
adjust the H/V POS, H/V SIZE, and phase.
REAR connection
1. Menu / Exit
This button is used to bring up or disappear the
controls menu. Exits from the OSD system and the
selected function.
2. Down / Brightness (
Moves down the menu lists in the OSD.
Decreases the value of brightness.
3. UP / Contrast (
Moves down the menu lists in the OSD.
Increases the value of brightness.
5. LED
A green indicator lights when the power is on and
input signal (the indicator will not light when the
power is off). A red indicator lights when the power
is on and input NO signal.
6. Power On/Off
button).
When power is supplied, the monitor will come on.
This button then turns the monitor on and off.
1. DC JACK
Place the plug from the supplied table-top power
supply into the VDC connector. Input at the
monitor is VDC from the TT universal AC supply
(00-40VAC, see specifications table for AC/DC
details).
2. PC VIDEO INPUT
Connect to the video output port on your PC
3. SUPER VIDEO INPUT
Used to connect a S-Video signal from a camera
or VCR
4. VIDEO INPUT
Used to connect a BNC Video signal from a camera
or VCR
5. Mounting Options
Four 75mm pitch VESA wall mount compatible
3
)
)