Use - AERMEC KTL M Manuel D'utilisation Et D'installation

USE

SWITCH-ON/SWITCH-OFF
• Press the to switch the fan coil unit on/off.
The Heat (heating) of Cool (cooling) light will fl ash when the receiver receives the on
signal, these show that the fan coil unit has started in the working mode that was active
before last switch off.
• By pressing the button on the receiver when the fan coil unit is
off, you will switch it on automatically (temperature set at 22°C and
automatic ventilation speed).
• By pressing the button on the receiver while fan coil unit is
working you switch it off.
To make sure that the fan coil unit will operate properly, make sure that the plants circula-
tes water at the temperature suitable to the desired working mode. In particular make sure
that during use in Winter the heat pump or boiler are on and the same for the refrigerator
in the Summer. KTL can also be installed on fan coil units for sensitive only cooling.
MODE
CLOCK
STRONG
TIMER
SLEEP
SET
ROOM I FEEL
1
"I FEEL" FUNCTION
• Press the pbutton to enable temperature detection from the probe in the
I FEEL
remote control and deactivate the probe on the coil unit.
• The symbol appears on the display
When this function is inserted the fan coil unit works according to the temperature
read by probe in the remote control.
To obtain a correct reading of the temperature, do not hold the remote control or put
it near to heat sources or cold air currents.
20
"ROOM" THERMOMETER FUNCTION
• Press the button to display the room temperature near to the remote control.
ROOM
The thermometer function does not infl uence the normal working functions, its only function is that
of displaying the temperature value.
The displayed temperature is detected by the probe in the remote control.
To obtain a correct reading of the temperature, do not hold the remote control or put it near to heat
sources or cold air currents.
.
1
CLOCK
TIMER
SET
ROOM
1
MODE
MODE
STRONG
SLEEP
I FEEL
1