Preliminary Operations; Replacing The Batteries; Setting The Time - AERMEC KTL M Manuel D'utilisation Et D'installation

PRELIMINARY OPERATIONS

REPLACING THE BATTERIES

Slide the battery slot on the back of the remote control
downwards.
Insert two 1.5 Volt high performance LR 03 alkaline batteries
(AAA).
Having inserted the batteries the time on the display should be
updated.
2
MODE
2
CLOCK
STRONG
1
TIMER
SLEEP
SET
3
ROOM I FEEL
FOLLOW THE INSTRUCTIONS GIVEN BELOW
• The remote control signal can be received up to a maximum
distance of 7 metres.
• Communication between the remote control and the receiver
comes about by means of I.R. infrared rays, for this reason the
remote control is to be turned towards the I.R. receiver without
obstacles between them.
• The remote control and I.R. receiver are to be placed in a location
with not sources of heat, direct sunlight or fluorescent lighting and
at a distance of at least one metre from televisions or other electrical
equipment so that they do not interfere with transmission and
reception of infrared rays.

SETTING THE TIME

• Once the batteries are inserted, the clock on the display will fl ash and show
• Adjust the time by pressing keys
• Press the button to activate your choice.
SET
• To change the time, press the
time appears.
• Press the key to activate your settings.
SET
Batteries
2X1.5V AAA
/ until the correct time shows on the display.
function key and the
CLOCK
Batteries
Batteries
2X1.5V AAA 2X1.5V AAA
.
/ keys until the correct
19