Configuration Area; Possible Settings - Riello 5000VA Manuel D'installation

Configuration area

The configuration area groups together the main UPS operating parameters and displays its current status.
The parameters contained in this area can be changed directly from the display panel.
SETTABLE PARAMETERS:
Frequency: Output voltage frequency
Voltage: Output voltage
Mode: UPS operating mode
The image at the side shows the display zone for the settings
(configuration area) showing the three settable parameters.
How to change the settings:
To access the configuration area, hold the "SEL/SET" button down for at least 2 sec.
The word "SET" will light up and an arrow ( ► ) will appear to the left of Frequency.
The arrow shows the selected setting. To select a different parameter press the "SEL/SET" button.
To change the selected item, press the "ON" button.
To exit from the configuration area, hold the "SEL/SET" button down for at least 2 sec.

POSSIBLE SETTINGS

□ 50 Hz
Frequency:
□ 220 V
Voltage:
□ ON LINE
Mode:
NOTE: Changes in the output frequency configuration will only become effective when the UPS has been
completely shut down and restarted (via the general switch).
THE OUTPUT FREQUENCY AND VOLTAGE PARAMETERS MUST BE
COMPATIBLE WITH THE PARAMETERS OF THE LOAD POWERED BY
□ 60 Hz □ Off (frequency auto-sensing)
□ 230 V □ 240 V
□ ECO □ SMART
THE UPS
□ STBYOFF
U
SE
Frequency
Voltage
Mode
53