Measurements Display Area; Single-Phase Connection - Riello 5000VA Manuel D'installation

Measurements display area

The most important measurements regarding the UPS may be posted on the display in sequence.
When the UPS is switched on, the display shows a reading of the mains voltage value.
To change to a different display, press the "SEL / SET" button repeatedly until the desired quantity appears.
If there is a failure / alarm (FAULT) or a block (LOCK), the display will automatically show the type and
code of the corresponding alarm.

Single-phase connection

Some examples are shown below:
(1)
GRAPHIC EXAMPLE
(1)
The values shown in the images in the table are purely indicative.
(2)
The FAULT/LOCK codes can only be displayed if they are active (i.e., if there is a fault/alarm or a lock).
DESCRIPTION
Mains voltage
Mains frequency
Voltage output from the
UPS
Output voltage frequency
Residual battery back up
time
Percentage of battery
charge
(1)
GRAPHIC EXAMPLE
Percentage of the applied
U
SE
DESCRIPTION
Total battery voltage
load
Current absorbed by the
load
Temperature of the
cooling system for the
UPS internal electronics
(2)
Fault/Alarm : the
corresponding code is
displayed
(2)
Lock : the
corresponding code is
displayed
51