Ingress Protection - WIKA P-30 Mode D'emploi

6. Commissioning, operation
Specifications
Description
Angular connector DIN 175301-803 A
Circular connector M12 x 1 (4-pin)
Circular connector M16 x 0.75 (5-pin)
Bayonet connector
CANopen M12 x 1 (5-pin)
USB
Cable outlet
The stated ingress protection (per IEC 60529) only applies when plugged in using
mating connectors that have the appropriate ingress protection.
6.3 Functional check
The output signal must be proportional to the prevailing pressure. If this is not the case, this may indicate
a damaged diaphragm. In this case, see chapter 8 "Faults".
6.4 Installation of the service interface
Only required for analogue instruments
Hardware requirement:
Spare USB port
■
USB adapter cable (order No.: 13193075 incl. software CD)
■
Suitable voltage supply for the pressure transmitter
■
System requirement:
Mircosoft Windows 7, Windows 8, Windows 8.1 (32 / 64 bit), Windows 10 (64 bit)
■
WIKA software EasyCom 2011 (CD containing software included with order No.: 13193075 or is
■
available for download at www.wika.com)
WIKA operating instructions precision pressure transmitter model P-3x

Ingress protection

IP 65
IP 67
IP 67
IP 67
IP 67
IP 67
IP 67
EN
19