Operation; Using The T 785 - Main Menu; About The On-Screen Display (Osd); Main Menu - NAD T785 Manuel D'installation

ABOUT THE ON-SCREEN DISPLAY (OSD)

The T 785 receiver employs a simple, self-explanatory system of on-screen
display "menus" that will appear on the connected video monitor/TV. These are
required during the setup process (and are useful in day-to-day operation), so
be sure to connect the monitor/TV before proceeding with setup.
DISPLAY THE OSD
Press either or ENTER buttons of the HTRC 1 remote control or front panel
to display the T 785's Main Menu on your video monitor/TV. If the OSD does
not appear, check your MONITOR OUT connections.
NAVIGATING THE OSD AND MAKING CHANGES
To navigate through the OSD menu options, please do the following using
the HTRC 1 or corresponding front panel buttons:
1 Press to select a menu item. Use
to move up or down the Menu selections. Repeatedly press
advance or go further into sub-menus of a desired menu item.
2 Use
keys to set or change the parameter value (setting) of a menu
item.
3 Press to save the settings or changes done on the current menu or
sub-menu. Pressing will also return the user to the previous menu or
exit from a particular menu.

MAIN MENU

The Main Menu contains the menu options for 'Listening Mode' , 'DSP
Options' , 'Tone Controls' , 'Picture Controls' , 'Zone Controls' and access to
'Setup Menu. '
To navigate through these Main Menu options and their sub-menu
selections, please refer to and follow the directions stated in the sections
'Display the OSD' and 'Navigating the OSD and Making Changes. '
NOTE
The individual configurations set forth at 'Listening Mode' , 'DSP Options' ,
'Tone Controls' and 'Picture Controls' are carried over whenever they are
enabled during A/V Preset setting. Please see the section 'AV Presets' for
reference.
keys or in some cases, ENTER,
to
USING THE T 785 – MAIN MENU

LISTENING MODE

The T 785 offers distinct listening modes, tailored for different types of
recording or program material. With a two-channel (Stereo) source, the
following listening modes can be selected:
STEREO
All output is directed to the front left/right channels. Low frequencies are
directed to the subwoofer if one is present in the Speaker settings. Select
'Stereo' when you wish to listen to a stereo (or monaural) production, such
as music CD or FM broadcast, without surround enhancement. Stereo
recordings whether in PCM/digital or analog form and whether surround-
encoded or not encoded, are reproduced as recorded. Multi-channel digital
recordings (Dolby Digital and DTS) are reproduced in "Stereo Downmix"
mode via the front left/right channels only as Lt/Rt (left/right-total) signals.
DIRECT
The analog or digital sources are automatically played in their native
formats. All the source's audio channels are reproduced directly. This
mode recreates the original sound most faithfully thereby producing
outstandingly high quality audio.
PRO LOGIC
Two-channel recordings, whether stereo or surround-encoded, are
reproduced with Dolby Pro Logic surround processing, yielding output to
front left/right, center and discrete left/right surround channels (assuming
these are present in the current 'Speaker Configuration'). The surround
channel is monophonic, but it is reproduced in both surround speakers.

OPERATION

1