Consumer Information - Moen MOENTROL 3320 Instructions D'installation

Outlet #1
Hot Water Inlet
Pipe Connections to the Valve
Connect the piping to the valve as shown
above. If soldering copper to copper, be sure to
remove the cartridges prior to soldering (see
Cartridge removal step).
NOTE Do not use outlet port on Moentrol Valve.
Unplugging and use of this port will cause
improper functioning of the valve.
MOEN LIFETIME LIMITED WARRANTY
Moen products have been manufactured under the highest standards of quality and workmanship. Moen warrants to
the original consumer purchaser for as long as the original consumer purchaser owns their home (the "Warranty Period"
for homeowners), that this faucet will be leak and drip-free during normal use and all parts and finishes of this faucet will
be free from defects in material and manufacturing workmanship. All other purchasers (including purchasers for industrial,
commercial and business use) are warranted for a period of 5 years from the original date of purchase (the "Warranty
Period" for non-homeowners).
If this faucet should ever develop a leak or drip during the Warranty Period, Moen will FREE OF CHARGE provide the
parts necessary to put the faucet back in good working condition and will replace FREE OF CHARGE, any part or finish that
proves defective in material and manufacturing workmanship, under normal installation, use and service. Replacement
parts may be obtained by calling 1-800-289-6636 (Canada 1-800-465-6130), or by writing to the address shown. Proof
of purchase (original sales receipt) from the original consumer purchaser must accompany all warranty claims. Defects or
damage caused by the use of other than genuine Moen parts are not covered by this warranty. This warranty is applicable
only to faucets purchased after December 1995 and shall be effective from the date of purchase as shown on purchaser's
receipt.
This warranty is extensive in that it covers replacement of all defective parts and finishes. However, damage due to
installation error, product abuse, product misuse, or use of cleaners containing abrasives, alcohol or other organic solvents,
whether performed by a contractor, service company, or yourself, are excluded from this warranty. Moen will not be
responsible for labor charges and/or damage incurred in installation, repair or replacement, nor for any indirect, incidental
or consequential damages, losses, injury or costs of any nature relating to this faucet. Except as provided by law, this
warranty is in lieu of and excludes all other warranties, conditions and guarantees, whether expressed or implied,
statutory or otherwise, including without restriction those of merchantability or of fitness for use.
Some states, provinces and nations do not allow the exclusion or limitation of incidental or consequential damages, so
the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may also
have other rights which vary from state to state, province to province, nation to nation. Moen will advise you of the
procedure to follow in making warranty claims. Simply write to Moen Incorporated using the address below. Explain the
defect and include proof of purchase and your name, address, area code and telephone number.
3
Outlet #2
Cold Water Inlet
Before installing the IPS version of the valve,
CC to IPS adapters need to be soldered into
the outlet ports of the transfer valve as
shown. Remove the transfer valve cartridge
before soldering the adapters.
Cartridge Removal (for soldering only)
The cartridges will need to be removed prior to
soldering the copper piping to the valve.
1. Remove the cartridge retainer clips using a
pic or similar tool by pulling the clips up and
out through the top slot.
2. Once the retainer clips are removed, use a
pair of pliers to pull the cartridges out of the
valve body.
3. Re-install the cartridges to their correct
locations after the valve body has
returned to room temperature.
4. Re-install cartridge retainer clips.

CONSUMER INFORMATION

Faucets made of leaded brass alloys may contribute small amounts of lead to
water that is allowed to stand in contact with the brass. The amount of lead
contributed by any faucet is highest when the faucet is new. The following steps
may reduce potential exposure to lead from faucets and other parts of the
plumbing system:
• If you wish to flush the entire plumbing system of water that has been standing
in the pipes or other fittings, run the cold water until the temperature of the
water drops, indicating water coming from the outside main.
1 (800) BUY-MOEN
In the U.S. call our toll free Helpline number, for answers
to any product installation, or warranty questions.
Rest of Canada: 1-800-465-6130
Moen Incorporated • 25300 Al Moen Drive • North Olmsted, OH 44070-8022 U.S.A.
In Canada Moen Inc. • 2816 Bristol Circle • Oakville, Ontario L6H5S7
HELPLINE:
[289-6636]
In Canada:
Toronto: 905-829-3400;
In Mexico:
(84) 88-08-26, 88-08-27,
o 91-800-84-345
INS282B