Operation; Commissioning - Renkforce PHZ-700 Mode D'emploi

9. Operation

Always pull the mains plug before filling the tank.
Never fill the tank with flammable liquids or add such to the fluid. Use only suitable water-based
fog liquids (for suitable fluids, see online on the product page under „Accessories").
Never tilt the device. Liquids may leak out or enter the inside of the device and cause damage
there or injure the operator.
Make sure that no fluid enters the inside of the device when you are filling it with fog liquid. This
may cause damage to the device and potentially fatal electrical shock.
DMX operation always takes precedence over manual operation. Once a DMX signal is pen-
ding, manual mode is deactivated and the respective function trigger at the device is deactiva-
ted.
Ensure that the tank never runs empty during fog operation. If this happens anyway, the conveyor
pump switches off automatically. Switch off the device without delay using the mains button ON/
OFF and let it cool off.
Only top up the tank after the device is cooled off. The fill level of the tanks is evident from tank
fill level display on the side of the device.
Slight fog lag after deactivation/disconnection of a device is normal and does not suggest a
defect.
If you no longer require the device, disconnect the mains plug and let the device cool down.
Then empty the tank. This prevents leaking of liquid during transport or storage.
a) Commissioning
• Ensure that the mains plug is not plugged in.
• Unscrew the tank cover from the device and fill fog liquid into the tank. The fill level can be read on the
side at the tank fill display.
• Then screw on the tank closure lid again.
• Plug the mains plug into a mains socket with a protective ground contact.
• Switch the device on using the ON/OFF mains switch. With the device on, the mains switch lights up and
the device heats up.
• Heating up takes approx. 3-4 minutes. During this process, the display indicates WARMING UP.
• When the device has reached operating temperature, the display shows READY HAZE and the device is
ready.
• There is an adjustable air exit at the fog exit that influences the ejection direction of the fog. Adjust the
air guide sheet as desired after loosening the lateral knurled screw.
24