Connection; Connection Of A Dmx Controller - Renkforce PHZ-700 Mode D'emploi

Acceptance test (in case of industrial/public use):
Before first use and after any significant modifications, the installation (including the electrical
connections) must be inspected by an official expert.
A yearly inspection by an expert is required.
At least every 4 years, an acceptance test must be carried out by an expert.
• Set up the device under observation of the above safety notes.
• Alternatively, the device can also be attached with the mounting bracket.
• Always observe horizontal setup for this.

8. Connection

a) Connection of a DMX Controller
Only connect the device to a DMX controller with a DMX-512 protocol.
• Connect the connection DMX IN with the output of the DMX controller.
• Use a screened XLR cable for this. The controller must have 3 free control channels.
• Connect DMX OUT with the DMX input of the subsequent device (if present).
• If the hazer is the last or the only device in the DMX chain, insert a plug with a 120 ohm/0.25 W termina-
ting resistor into the DMX OUT socket (between Pin2 and Pin3).
Pin assignment of the DMX connection: Pin1 = earth / Pin2 = (-) / Pin3 = (+).
22