Sanyo CE42LM4N-NA Manuel D'utilisation page 4

Step : 1 Connections (Essential)
■
Connect the display unit to VGA, BNC and Peritel Scart
connector as required.
Security fixing point
Wall mount
fixing positions
1. Connect the power cord to the IEC socket on the rear of the
monitor as shown above
2. Connect the other end of the power cord to a wall outlet.
✐
As this product does not have a power On/Off switch, please
ensure your mains plug is easily accessible.
✐
The display unit is prepared for a power voltage AC100~240V,
50Hz/60Hz. To completely switch off the mains, or when the
display unit is not to be used for an extended period of time, it is
advisable to disconnect the power cord from the power outlet or dis-
connect the power coupler..
✐
Please use the correct power lead supplied with the set for your
area
3.
Warning: To prevent injury, the unit must be securely attached to
the wall in accordance with the installation instructions.
WARNING! High voltages are used in the operation of
this set. Refer service to qualified service personnel.
1.■ HDMI (High Definition Multimedia Interface)
This TV set has an HDMI connector. When connected to the HDMI
source and HDMI is selected using the remote control, there is a short
time period before the picture appears at a much higher resolution.
This connection is located at the back of the TV set next to the aerial
socket.
4
INST
INST
PJ-Net
HDMI AV2 audio
IN
Switch Audio monitor
Out
PC
RS232C
Services Serial ports
IN/ Out
AV3 IN/Out
BNC
AV2 IN/ Out
BNC
Serial
ALLA TION
ALLA TION
2. Y,Pb,Pr connection (AV2)
This LCD monitor has a choice of Y, Pb, Pr or RGB , H/V connections.
You can connect your DVD player to the Y, Pb, Pr terminals instead
of using a scart lead. This can support high definition in analogue
component form. RGB, H/V can be used as a PC input via the BNC
terminal.
IEC
Serial port
Socket
PJ-net
Service
3. PC connection
This display unit has a PC connector. You can connect a PC to the
Display unit and use it as a monitor(see page 7).
To switch between AV1, RGB, AV2 RGB H/V or Y, Pb, Pr, AV3, HDMI
or PC mode, press the TV/ AV switch on your remote control
repeatedly or press and hold the the TV/AV button for a few seconds
and selection menu will appear on screen use the e or d buttons to
select the correct mode.
4. RS232C IN/OUT: Is an input for external commands to control the
monitor (see page 8)Use the switch to change between RS232/ PJ
net
5.
PJ Net IN/OUT: Has the ability for PJ-NET to be connected to
control the monitor using a network.
Step : 2 Remote control battery installation
Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the
batteries match the "+" and "-" marks inside the unit into the remote
control handset.
Serial
Port-IN
Peritel (Scart)
Serial
Port-OUT