General Guidelines - Perel CFAN040PS Mode D'emploi

3.

General Guidelines

•
Refer to the Velleman
manual.
•
All modifications of the device are forbidden for safety reasons. Damage caused by
user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
•
Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising
from the possession, use or failure of this product.
•
Keep this manual for future reference.
4. Overview
Refer to the illustrations on page 2 of this manual.
1
2
3
4
5
6
7
8
5. Assembly
Assemble the fan as follows:
1. Loosen the grille mounting nut from the motor housing.
2. Position the rear grille firmly to the motor housing. Fasten it with the mounting
nut.
3. Push the fan blade along the motor shaft.
4. Hang the front grille on the rear grille using the grille clamp. Fix the grilles together
with the clips on the rim of the front grille. Fix with the screw and nut.
5. Mount the height adjustment ring onto the lower pole. Insert the upper pole into
the lower pole and tighten the height adjustment ring.
6. Fix the base onto the stand.
Your fan is now ready for use.
6. Operation
1. Place the fan on a flat and sturdy surface. Make sure no objects (e.g. curtains) can
be sucked into the rear of the fan.
2. Insert the power plug into the mains.
3. Set the desired output speed using the speed buttons:
V. 03 – 20/02/2020
®
Service and Quality Warranty on the last pages of this
grille mounting screw
front grille
fan blade mounting screw
fan blade
fan blade mounting nut
rear grille
motor shaft
motor housing
0 = stop; 1 = low; 2 = medium; 3 = high
CFAN040PS
9
10
11
12
13
14
15
16
5
oscillation knob
speed buttons
body
locking knob
upper pole
height adjustment ring
lower pole
base
©Velleman nv