Assembling The Unit - Elite Volare Mag Force Elastogel Mode D'emploi

EN
ASSEMBLING THE TRAINER BASE
•
Open the trainer base and set it on a flat, stable
surface.
•Picture 1 shows how to apply the handle (G).
When fitting the handle to the axle support,
make sure the flat surface of the axle screw
matches the inside of the handle.
Use the M6x16 (I) screw to fix the handle.

ASSEMBLING THE UNIT

•
Remove the resistance unit from its carton and
install it on the Spring Plate as shown in illustra-
tion nr. 2. On the Spring Plate (H) there are two
pairs of holes, use the holes according to the rear
wheel diameter, as show in illustration nr. 2.
BICYCLING INSTALLATION
•
Make sure that the bicycle's rear wheel skewer
is tight.
•
Position the locking ring (F) as shown in illustra-
tion nr. 3 and using the handle, loosen the axle
support (E) until the right support cup (D) comes
in contact with the trainer's frame (illustration nr. 4).
12
G
28"
I
1
•
Push the Spring Plate (H) down as far as possi-
ble towards the floor to automatically engage the
Spring Plate lock (Fig. 5).
26"
2
•
Carefully lift your bicycle in position, insert the
rear wheel axle from the left hand side into the left
hand axle support cup (C) (as shown in illustration
nr. 6). To have a more secure locking of the bicycle
on the frame, the left support cup (C) (where the
QR lever gets blocked) is turned up (Fig. 7).
F
3
4
5