Milk Parameters; Cup Heater; Alarms / Notifications - Thermoplan Nespresso AGUILA AG440PRO Manuel De L'utilisateur

Menu settings

- Milk parameters

• Milk foam settings:
- Hot foam
- Cold foam
• Refrigerator settings

- Cup heater

Milk foam settings
To change the fluidity of the
milk foam, simply change the
% of air in the milk foam as
shown on this page:
• -10%: more liquid foam
• 0%: installation setting
• +10%: more solid foam
The settings for the left milk
container do not automatically
match the right milk container.
Both milk settings have to be
done independently!

Alarms / notifications

What to do if a "Call techni-
cian" message appears?
Call your Nespresso repre-
sentative.
Milk parameter: Milk foam
settings
Press the rinse button for 3 s.
Enter the user menu
USER MENU
MILK PARAMETERS
Select the "MILK PARAMETERS"
menu
Enter
MILK PARAMETERS
Hot foam left = 0.0 %
Select "Hot foam left = 0.0 %"
Enter
Hot foam left = 0. %
[ -10.0 .. ◄ 0 % ► .. 10.0]
Increase or decrease the amount
of air in the hot milk foam if
required. Range: -10 % to 10 %
from default.
Enter
MILK PARAMETERS
Hot foam left = 3.0 %
Repeat this procedure for
Hot foam right, Cold foam left,
Cold foam right if necessary.
Exit the menu.
Description Display message
Change water filter
Service required
Milk container(s)
Ready
empty
Milk level low
Ready
Automatic rinsing
Rinsing in progress
mode
(5 min delay)
Cleaning required in
Ready
x.yy h.
Cleaning required in x:yy h
Milk system cleaning
Ready
required
Milk parameter: Refrigerator
settings
Press the rinse button for 3 s.
Enter the user menu
USER MENU
MILK PARAMETERS
Select the "MILK PARAMETERS"
menu
Enter
MILK PARAMETERS
Cooling temperature = 5.0 °C
Select
"Cooling temperature = 5.0 °C"
Enter
Cooling temperature = 5.0 °C
[ 4.0 .. ◄ 5.0 °C ► .. 8.0]
Increase or decrease the cooling
temperature if required or set to
DEFAULT (recommended).
Enter
Exit the menu.
LED status
Change water filter
Ready
Alternating
Service required
Ready
Alternating
Top up milk
Alternating
Milk level low
Alternating
Please wait
Alternating
Cleaning required
Alternating
Cup heater
Press the rinse button for 3 s.
Enter the user menu
USER MENU
MACHINE PARAMETERS
Select "MACHINE PARAMETERS"
menu.
Enter
MACHINE PARAMETERS
Cup heater = On
Select
"Cup heater = On"
Enter
Cup heater = on
◄ On ►
Select "On" or "Off"
Enter
Exit the menu.
Remarks
Immediately call your Nespresso
representative.
Immediately call your Nespresso
representative.
Milk products are locked.
Fill up the milk container(s) (in fridge).
Clean the suction tubes to ensure that
milk residue is not blocking the sensors.
Indicates that the milk container(s) will
soon be empty.
Fill up the milk container(s) (in fridge).
Automatic rinsing of external milk system
starts 5 min after the last milk-based
beverage preparation. "Rinsing in pro-
gress" and "Please wait" appear on the
display. LEDs start to flash 10 s before
rinsing.
When the timer ends, the machine will
be locked until it is cleaned.
Milk products are not available.
Start the cleaning procedure as described
on ► page 14 .
EN
17