Basic Operation; Turning The Power On; Turning The Power Off - Teac AP-505 Mode D'emploi

In order to protect the speakers, turn the power for systems that this
unit is connected to on and off in the following order.
NOTE
This explanation assumes that a preamplifier is connected to this
unit.
When connecting a UD-505, NT-505, UD-503 or NT-503
IMPORTANT NOTICE
Set the LINE OUT LEVEL to VARIABLE on the UD-505, NT-505, UD-503
or NT-503 in advance.
NOTE
o The UD-505, NT-505, UD-503 and NT-503 are equivalent to
preamplifiers.
o When using a UD-505, NT-505, UD-503 or NT-503 as a USB DAC
or using an NT-505 or NT-503 as a network player, it functions as
a preamplifier and a source device.
Connection example

Turning the power on

1
Minimize the volume of the preamplifier.
If using a device that cannot have its volume adjusted when it
is off, minimize the volume after turning it on.
2
Turn the source device on.
3
Turn the preamplifier on.
Source device
CD player or other audio out-
put device
Preamplifier
Preamplifier or other device
with a preamplifier function
(such as a DAC)
AP-505
4
Turn this unit on.
The level meters will blink and the mute function will turn on.
When the amplifier operation stabilizes, they will light and the
mute function will turn off.
5
Start playback on the source device, and adjust
the volume on the preamplifier.
Adjust the preamplifier volume after the level meters on this
unit stop blinking and stay lit.

Turning the power off

1
If a connected device is playing back, stop
playback.
2
Minimize the volume of the preamplifier.
3
Put the unit into standby mode.
4
Turn the preamplifier off.
5
Turn the source device off.

Basic operation

EN
13