Recording; Basic Operation - Teac A-H300mkIII Manuel Du Propriétaire

Basic Operation

2
3
1 To protect speakers from a sudden high-level signal,
turn the VOLUME knob counterclockwise to minimize
the volume.
∞
– (infinity): minimum volume
0dB: maximum volume
2 Press the POWER switch.
The unit enters standby mode, and the standby indicator
lights.
3
Press the STANDBY/ON switch to turn the unit on.
4
Select a source by turning the INPUT SELECTOR (or
pressing one of the INPUT SELECTOR buttons of the
remote control unit).
5
Play the source, and gradually turn up the volume to
the required level by turning the VOLUME knob.
10
1 5
4
The standby indicator
goes off.

Recording

1 Select a source to be recorded by turning the INPUT
SELECTOR.
Do not select TAPE 1 or TAPE 2.
2 Set the REC SELECTOR to "SOURCE".
3 Start recording on the cassette tape deck connected to
TAPE 1 or TAPE 2 (or both).
You can use both TAPE 1 and 2 for recording.
< The volume and tone control have no effect on the recording
signals.
INPUT SELECTOR
REC SELECTOR