Remote Control Unit; Basic Operation - Teac A-H380 Manuel Du Propriétaire

Remote Control Unit

The amplifier and Reference 380 series connected by remote
control cords can be operated by the provided remote control
unit.
When operating the remote control unit, point it towards the
REMOTE SENSOR on the front panel of the A-H380.
< Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there are
any obstacles between the unit and the remote control.
< If the remote control unit is operated near other appliances which
generate infrared rays, or if other remote control devices using
infrared rays are used near the unit, it may operate incorrectly.
Conversely, the other appliances may operate incorrectly.
Battery Installation
1. Remove the battery compartment cover.
2. Insert two "AAA" (R03, UM-4) dry batteries. Make sure that the
batteries are inserted with their positive "+" and negative "_"
poles positioned correctly.
3. Close the cover.
Battery Replacement
If the distance required between the remote control unit and
main unit decreases, the batteries are exhausted. In this case
replace the batteries with new ones.
Precautions concerning batteries
< Be sure to insert the batteries with correct positive "+" and
negative "_" polarities.
< Use batteries of the same type. Never use different types of
batteries together.
< Rechargeable and non-rechargeable batteries can be used. Refer
to the precautions on their labels.
< When the remote control unit is not to be used for a long time
(more than a month), remove the batteries from the remote
control unit to prevent them from leaking. If they leak, wipe
away the liquid inside the battery compartment and replace the
batteries with new ones.
< Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
10

Basic Operation

1
A
1 Press the power switch to turn the unit on.
When you use the system control function, and when you use
the daily timer or the sleep timer of the T-H380, set this switch on,
and turn the system on/standby using the remote control unit.
The Standby/On indicator turns from orange to blue.
< When you turn on the system, the source that was selected last
time will start playback automatically.
2 Select a source
Select a source by turning the INPUT SELECTOR knob (or pressing
one of the INPUT SELECTOR buttons of the remote control unit).
3 Control the units to play
Please read the instructions of each component.
4 Adjust volume
Gradually turn up the volume to the required level by turning the
VOLUME knob.
2 4
C D
B
Standby/On indicator