System Indicators; Pump Front Panel - ConMed Linvatec 10k Manuel D'utilisation

E
❶
❷
❸
❹
1.5

System Indicators

1.5.1

Pump Front Panel

❶
Pump Rotor — Contains the pump rollers
that the tubing set loop mounts over. Rollers
rotate to assist fluid flow.
❷
"Run/Stop" Button — Press to start the
pump. Press again to stop the pump.
❸
Illuminated Display — Displays pressure,
in mmHg, for arthroscopic procedures, or
percentage of fluid flow (%) for
laparoscopic procedures. The designated
indicator will illuminate. Also displays any
user information codes or special
instructions.
❹
Standby Power Switch — To activate the
pump, place this switch in the on position.
To set the pump to stand-by mode, place
this switch to the off position.
❺
Pressure Increase Button — Press to
increase pressure.
❻
Pressure Decrease Button — Press to
decrease pressure.
❼
Hand Held Remote Control Receptacle -
Accepts the connector of the C7115
Remote Control.
❽
Pressure Sensor Window — Contains
pressure sensors that detect the pressure
flowing through the attached tubing set.
CAUTION: Keep the pressure sensor
window area clean. Do not allow sharp
objects to come in contact with this area.
E-4
❺
❻
❼
❽